langkah-langkah menggunakan blender menggunakan bahasa inggris dan indonesia secara urut

Before the blender is used, first read the book / brochure that is included when you buy a blender to avoid damage to equipment and accidents that may arise. In general, the procedure of blender work is as follows:

(1) Make sure that the saklah ON-OFF blender is in OFF position.

(2) Prepare all materials to be blended. Separate grain materials such as corn, pepper and ingredients that are hard agag from soft ingredients such as bananas, apples, tomatoes, lombok and others.

(3) Use a bowl that is suitable for rendering purposes. Bangkok small to smooth the hard and dry material, while the soft and wet material use a large bowl.

(4) Put a bowl of dough on top of the right bowl, then turn until the bow can not be pulled up leaving the cradle. There is also a blender that does not need to be played, but the bowl is held by hand. Small bowls first filled with the material to be blended, then covered with a crushing knife holder, then seated on a blender holder. As for the large bowl is not the case. Mangkon batter first sit on a bowl holder and then filled with materials to be blended.

(5) After the work step is good and safe, press the ON-OFF switch to move the switch from OFF position to ON position. At that time the blender motor will spin and rotate the blender blade inside the blender mow. Submission or destruction of material begins to take place. Attention! Do not lift the bowl from the bowl when the blender motor is spinning. Dangerous!

(6) After the texture of the material feels smooth (sound of motor rotation and the blade sounds fine), turn off the motor (position the ON-OFF switch in OFF position).

(7) Raise the bowl from the seat. Attention! Do not operate the motor for too long over an hour without rest for cooling. Dangerous! Can singe blender motor windings.

(8) When finished using a blender, immediately cleaned. Wash clean with water, except the body. Only a blender body that should not be cleaned or washed with water is wiped with a clean cloth, because in it there is a motor and a series of electrical. Washing with water can cause the motor and electrical circuit in it to be shorted or short circuited and burned.

(9) Keep the blender in a safe place, not damp, not sun-dried, not tertetesi water or a particular liquid or not bombarded, tidah easy fall, not easily accessible children who do not understand the use of blenders.